Call for Availability
800.941.2446
1 - Lectrosonics M2T IEM / IFB Transmitter with Dante
M2 Duet System M2T - IEM/IFB Transmitter
- IEM (Wireless Monitor) with digital RF transmission
- 24-bit digital audio
- 2 independent stereo audio transmissions per 1/2 RV enclosure
- USB port for firmware updates
- Fully Dante™ compatible
- IR (infrared) port for fast setup
- Up to 50 mW per Rf carrier
- All metal housing
- Compatible with Wireless Designer™ Software
The M2T half-rack transmitter houses two independent stereo transmitters allowing for up to four stereo or dual-mono transmissions in a single rack space. The audio inputs can be individually configured to be analog or Dante compatible. The analog input connectors arefull size XLR/TRS combo types for balanced line level analog signals while the input preamp circuits use aspecial balanced amplifier with very high common mode rejection to minimize hum and noise. A Dante™ Ultimo™ interface via dual RJ45 connectors accepts Dante networked audio inputs and can cascade the digital stream to additional units via CAT6 cables. An additional RJ45 jack provides an Ethernet connection for programming and control via Wireless Designer™ software and a USB jack on the front panel allows for firmware updates. The transmitter features a full color, backlit LCD for high visibility in any environment, while the chassis is all-metal and can be racked singly or in pairs using included rack mount hardware.
RF Power Output: 2 RF carriers, 25 mW, 50 mW; adjustable.
Antenna Output: 2 x BNC sockets
Operating Frequencies: 470.1 – 607.975 MHz
Frequency Selection Steps: 25 kHz
Frequency Stability: ± 0.002%
Modulation: 8 PSK
Emission Designator: 200KG7E
Spurious Radiation: >90 dB below carrier
Equivalent input Noise: –128 dBV
Audio Frequency Response: 20 HZ - 15 KHZ, -3 dB
Audio Input: -10 dBv or +4 dBu settings w/ ±5 dB trim
Audio Input Jack: 4 x combo XLR/TRS connectors
Dante Connection: 2 x RJ45. Internally routable with Ultimo 4x4 module
Ethernet Connection: RJ45
USB Connection: Micro USB on front panel for firmware updates
IRDA: IR transceiver for sync of receivers
Input impedance: Line: 2k Ohm
Headphone jack ¼ inch stereo jack
Power Requirements: 9-18V DC
Power Consumption: 5 Watts
Dimensions:
Height: 1.750 in. / 44.45 mm
Width: 8.375 in. / 212.7 mm
Depth: 7.750 in. / 196.8 m.
Specifications subject to change without notice.