The PSC Bell and Light System is a sure attention getter that will save time and money for producers and technicians alike. The heart of the system is a compact, rugged power supply that is designed to power up to 18 of our LED based Bell and Light Stations. This power supply contains provisions to allow ganging of additional power supplies should you have the need for very large systems. A single remote control will operate the entire system.

Each bell and Light Station is equipped with a loud 6” alarm bell and three bright, LED light panels. These stations have provisions to daisy chain (loop through wiring) additional stations. Each Bell and Light Station also contains a bell shut off switch and a convenient, ¼”-20 threaded insert for mounting purposes.

The entire PSC bell and Light System is remotely controlled by a small hand held controller box. This simple to operate remote control is connected to the power supply via a standard microphone cable which can be easily extended up to several hundred feet. The system is normally operated by the sound recordist or 2nd AD. All of the Bell and Light Stations operate on 12Vdc for added safety on the set. These LED Based stations operate using lower power than conventional incandescent lights so long cable runs of up to 500 feet are possible.

The PSC Bell and Light System will provide a convenient method of signaling all the cast and crew. One ring of the bell and flashing LED’s turned on signals the start of a shot (“Rolling and Action”), Lights off and two short rings of the bell signals the end of the shoot (“CUT”)